Small Prusament Spool Measuring Tape Holder

This holder is a remix of https://www.printables.com/model/177798-prusa-spool-logo by steffanders. I used the full spool piece (the flat sides) and then added cylinders to it so that it can be pressed together to form a whole spool. A five foot soft measuring tape can be wrapped around the spool.

This is a really easy print, and both the top and bottom pieces are in the same stl file. Once they print, just push them together (there might be a little bit of resistance), and then tightly wind the measuring tape around the spool for easy storage.

It can be printed in less than two hours and only needs ten grams of filament.

Print Settings: 

Default settings are fine.

Print at 0.2mm layer height or lower for a more detailed print.

15% infill

No raft or supports needed.