Support Studs for ikea CD Rack shelves

This is a copy of the small metal pin that goes on the inside of CD rack ("What's a CD?" you ask... you'll have to look that one up).

Like the original there is small taper from the middle to the end to ensure they get a tight fit as they go deeper into the hole.

Print Settings

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

100

Filament: Any PLA

Notes:

Perimeters: 4

On printers with a moving bed, e.g. Prusa's, don't print a lot at once. With such a small contact surface for each pin the force of moving back and forth is enough to break them off the bed.

4 at once seems safe. 10 at once seemed to be too many (one or more inevitably broke off and caused them all to fail).

I'd suggest a small brim if you want to print a lot at once.

Category: Organization