Wall Mount - Knew Concepts Mk.3 Fret Saw

This little hook can be mounted with 2x #8 3/4" countersunk screws. It has enough projection off the wall to work with all the different SKUs of the saw, but only with the blade-holding knobs facing away from the wall.

The throat is 3.5mm, just enough to leave a little play, but doesn't let the saw rock front to back much. It's wide enough that balance is not super difficult to find, but a second hook a few inches away can fix that problem entirely.

Requires about 12mm (~1/2") of room above the saw when installed to get  it on and off.

Printed with 0.15mm quality preset on MINI+ with marble PLA. Make sure to rotate the model so that one of the sides is on the print bed.