Floor vent diverter

In the spring, I found a new space for my printer which worked fantastically – until the first time we had to turn on the A/C, and I realised my cool air was blowing directly at the underside of the heated bed, causing all kinds of havoc.

This print is my solution to not have to stack boxes in front of the vent. It's designed to print with no supports, and for me it printed in a bit over 5 hours with a 0.6mm nozzle (though I did use a brim for adhesion). Shown is Amolen Ebony Wood filament, which gives it an elegant look to fit in with the wood floor.