Honeycomb Wall Cup Holders for 60mm + 75mm

This is a cup holder design in two different sizes to keep your cups and similar, round objects nicely on your Honeycomb Storage Wall (HSW) for easy retrieval. One model has an inner diameter of 60.5mm, holding a 60mm cup rather tight. The other model has an inner diameter of 76mm, lossely holding a 75mm cup. Of course, the holders can also be used to storew some other objects. For this, keep in mind that the inner height of the holders is only 6mm.   

What is needed?

• print the file with the dimensions in file name that you require
• no additional inserts needed

How to print

Use support for insert attached to the holder model(s). Or print without support and make manual corrections (e.g. by pulling off some unclean parts with pliers or by sanding a little - for me, this was perfectly fine).  

I suggest to stick with the original suggestions for printing holders and inserts for the honeycomb wall: Use any material you like (I used red PETG), with layer height of 0.2mm, 4 perimeters and 20% infill.