Pannier to Virtual Rear Seatpost Adapter

Converts a small horizontal rear pannier frame post into a vertical post for attaching a rear camera or light behind the pannier.

You'll need M3x30mm screws and nuts x4

I used some silicone (or rubber would work) between the adapter and the pannier to allow for sufficient tightening and grip.

Print 2 of these, one mirrored (most slicers should have this functionality, I used Cura).

Supports are recommended for the very top of the arch

I've included my Blender file in case it helps in changing the size or position of the post hole