Kylo Ren --- Colorized and modeled using Hueforge by Steve
Printed on a Bambulab P1P using BambuStudio slicer (with custom filament change gcode since slicer wouldn't pause on its own). These are large files so slicing takes forever normally.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.32mm
Filaments Used (designed in software):
PETG JAYO Black Transmission Distance: 0.3 (my print is PLA JAYO black)
PLA+ Sunlu Grey Transmission Distance: 2 (my print is accidentally a grey silk)
PLA+ Sunlu Red Transmission Distance: 6
Swap Instructions:
Black until layer #11 at 1.12mm
Grey until layer #13 at 1.28mm
Red for the rest.
Note: PETG and PLA don't mix so make sure you use PLA for the black.
The author marked this model as their own original creation.