Wallet for SD Cards
154
1224
18
5100
updated April 26, 2023

Makes

Comments

Thanks for your time and effort

I printed a personalized gift using this one, by adding some text to the cover during slicing. This is visible in the picture.

Nice economical model. I ended up shorting the bottom part X by 1mm to tighten up the fit of the cards, Otherwise they would fall right out.

nice and simple Design and it works as intended, pretty good!

SD Cards fit perfectly. The lid worked but was a little too flimsy for my tastes. I beefed it up a bit in a remix.

Works as expected, printed on Prusa MK4 IS 0.6
Transparent filament would probably be beneficial or cooler than all black which I used.

I can’t close and open because the sf holder is to high

Works as expected, and does so very well.