Mountable Thermostat housing to control the chamber fan on the P1P

I designed this housing to hold a thermostat bought off aliexpress (https://www.aliexpress.com/item/32981259938.html) to control the chamber fan installed based on another design (https://www.printables.com/model/427552-chamber-fan-duct-for-bambu-lab-p1p). It just slots into the hole on the right hand side of the printer where you can route all cables through.

Next steps for me is to route all the wires and connect everything up but this should then allow you to control the temp for the chamber fan to maintain at triggering the fan installed and enabling the use of the carbon filter. I will add more photos once those steps are complete.

It will still need a buck converter depending on the fan used but i am aiming on wiring in based on the wiring diagram in the images.

Use normal supports to cover any overhangs and print flat surface to the plate.