BringAuto Pi v4

BringAuto Pi v4 Enclosure models.

The original enclosure is printed from PETG at a standard quality prusa profile (0.2mm layer, 0.4mm nozzle, quality setting).

The default setting for supports works fine but can damage the outer part of the covers. It's recommended to use support only at the functional surface that is not visible when the device is assembled.

Feel free to use it and make alternations for your needs :).

• Support discussion: https://github.com/orgs/bringauto/discussions/categories/bringauto-pi
• Complete documentation: https://doc.bringautofleet.com/