FORMBOT Raptor 2 Cooler

Improved cooler design for the FORMBOT Raptor that uses the stock fan and mounting points. You will need M3 bolts and washers as well as an M3 tap is recommended to clean up the bold holes in the cooler. Washers are needed under the bolt heads to prevent the mount from distorting.

Prints as indicated on the Cura screen capture. I did not use supports, however you may want to use custom supports under the bolt holes to improve the bottom of the bolt holes.

When installing the mount ensure it is installed square.

Adjust the lowest part of the cooler to be 1-1.5mm above the end of the printer nozzle.

I built this for a friend and do not own my own Raptor. If you print this, I would appreciate any feedback that would help improve the design.

Print Settings

Rafts:

No

Supports:

No

Notes:

Print as indicated in the Cura screen capture. Do not use supports.