Mini lathe Carriage indicator holder

Fits the Busy Bee Mini Lathe cross slide. Likely fits others too, but I have no experience there. Step file included if that would be helpful. Added to model is a clearance slot for the gibb nuts, not shown in photos. If you do spin this for your lathe please post a make. There is a spot for a magnet, but I didn't find it necessary as it stayed in place by friction.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Doesn't Matter

Resolution:

draft works well.

Infill:

any

Notes:

There is a hole for a set screw to hold the indicator shaft, the intention was to tap the print and use a set screw, however the indicator on mine is a tight friction fit.

Comments and suggestions welcome, I'm a complete noob for Fusion 360. When I learned to draft when we used pen to paper.