Oculus Quest 2 Grip (with strap hole)

This is basically just the model by tigerflip, but with a hole cut into the bottom. I measured the straps on my controller to ensure they could pass through (including the plastic thingy) but the fit is snug. You should pinch the strap and push it through a little, then line up the plastic clip to go into the hole. Then, if you pull the strap, the controller should slide right into the grip and fit snug without the need for glue or anything like that (or at least, that's how it worked for me)

Print Settings

Supports:

No

Resolution: 

0.2mm

Infill:

30%

Filament:

Elegoo PLA 

Black

Notes:

I printed mine at a fairly low quality; 0.6mm nozzle with 0.2mm layer height, and 100mm/s in Cura. It has some obvious imperfections, but it feels comfortable and fits well, so I dont mind.

I used 30% cubic infill, but I also changed the wall thickness to be 3 lines thick.

This shouldn't need supports. I personally used a brim, but that's up to you.