Voron 2.4 A/B Belt Clamp

When assembling my Voron 2.4, I found holding the belts in place while I put the mount on for the StealthBurner was tricky.  I created this clamp that holds the belts in place making installation so much easier.  This requires you to remove two screws from the linear rails to mount.  Use M3 x 25 screws to hold the clamp.  The bottom clamp goes behind the belts to keep them at the same height as the carriage.  You need to squeeze the belts together to get the top clamp in place.  Do not over tighten the M3 bolt.  It doesn't take much pressure to hold the belts.  The arrow on the clamp points to the carriage to provide maximum gripping force.