WhamBam Mutant BMG Direct Drive

Nice model. Easy to print. You might want to use a brim on the fan shroud if you are using ASA or have issues with adhesion.

The position was a little off for the fan when using a V6 clone (second photo) so I modified it to line up better and get the airflow below the heater block.

I did run into some issues getting the stock fan shroud for the cold end to fit. I originally cut a small slot on the left side, but decided against it since my PINDA probe is so close. I'll also post the mount for the probe in case anyone wants to use it.

I have printed this in Prusa PC-Blend CF and it came out well. Everything fits together accurately. However, the BLT Touch hold is held to the Mutant plate by only 1 screw and is easily knocked out of position. I found another nice sliding BLT touch which can be held on by 2 screws and didn't use the cable holders. A simple zip tie though the left side screw access hole on the top adapter was sufficient to hold all the cables in place.