Xshot Longshot Half Dart Magwells

To use, print both the left and right halves of either the “Low Profile” or the “Flared" versions. Both of these use the internals from the included X-Shot half length adapter, and both will require some cutting of the adapters mag-release, so this isn't a mod for you if you want to go back to the original mag adapter. 

Both of these should be printed so that the “Outside” of the magwell is against the print bed. This will need supports that can be nasty to remove, but the inside of the magwell, as well as the internals slots will be smooth and the parts that were touching the bed or were supported are not seen. Its a tradeoff I was willing to make and I am glad I did. This is overall a better experience for me. As for the cut of the mag-release. See the photo of the orange part and cut along where the black line is. 

This mag adapter is compatible with both Katana and Talon Mags, but will see the same issue that the included adapter does where Talon mags can be Pulled out without using the mag release. The mag that was included with the Lonxshot is tighter as it is a cross between a Katana and Talon. 

Please let me know if you have any questions and I will do my best to respond.