Sample spool holder

This holder has been specially designed for Prusament filament samples. However, it can be used for any samples or remnants of filaments from the spool. Up to three samples can be placed on the holder, so it is also suitable for small multi-color prints.

Assembly instruction:
The whole model is made of two identical halves. So print the file twice and screw the two halves together. The prints are designed for mounting on an empty Prusament spool. It is not necessary to disassemble the Prusament spool!

During assembly, it is necessary to rotate one part by 180 ° so that the opposite screws fit into the smaller blind holes in the model.

Filament samples can be locked on a holder. You can also lock the end of the sample spool in the holder's groove to prevent tangling of the filament.

You will also need:
4x screws M3 x 16 (DIN 9090 - self-tapping screws for plastic)

Print instructions

STL

We recommend printing the model from PLA or PETG.

It is possible to use the default Prusa Slicer print settings for a 0.4 mm nozzle.

Recommended layer height: 0.15 - 0.2 mm
Perimeter: 2+
Infill: Rectilinear, 15 - 20%
Supports: Recommended

-

Designed by Josef Franc (ropak).