octopi stand

basic webcam stand. intended to use a little redneck engineering to mount device. i just duct taped it on there. use your imagination or just remix.

its a little wide for the raspberry pi so just scale it in your slicing software

the holes might get a little rough without supports but its fine to just send it as is.

i just whipped this together real quick on fusion 360 as i am learning the program & was looking for something practical to design.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

.28

Infill:

Filament: any any any