This part was created to allow filament to be fed through the top of an enclosure. It will allow lock into place and hold two pneumatic fittings to hold a ptfe tube.
Bill of Materials:
Start by printing the models.
Where you want the filament to enter the enclosure, drill a .5 inch hole. Insert the "bolt" into the top and secure it from the inside with the "nut".
Once the piece is installed, screw in the Pneumatic Fittings into the top and or bottom. Insert the PTFE tub through the fittings and lock the tube into place. Cut the PTFE tube to your desired length.
The author hasn't provided the model origin yet.