18650 Battery Case

Original was causing my battery shells to peel off. This one is size to perfection.

I printed in PETG and left it in my car all day with no issues. PLA is fine if you don't plan on leaving your case in a heated area. You will need one of each file. Everything in the print settings section can be changed depending on how you like to adult.

You will need 

• x4 M3x20 Screws
• x4 M3 Threaded insert
• 1 of each file

Print Settings:

• Nozzle size 0.6 mm
• Layer and initial Layer height: 0.3 mm
• Line width: 0.72 mm
• Wall line count: 2
• Top/Bottom: 3
• infill: 25% (your discretion)
• Infill Pattern: Gyroid (your discretion)
• Supports: off