Ubiquiti UBNT ToughSwitch EdgeSwitch 5XP low cover case houseing enclosure

Couple months ago I published a project of the top shell of enclosure of EdgeSwitch (vel ToughSwitch), from UBNT:

https://www.thingiverse.com/thing:4372312
https://www.prusaprinters.org/prints/50950-ubiquiti-ubnt-toughswitch-edgeswitch-5xp-top-cover

I did it because rubber coating of the enclosure dissolved after years and turned into sticky pulp. Right now I finished works on lower shell. Enjoy!

I also added feet and hangers which you can print and superglue to the shell underneath, in specially prepared holes.

Print instructions

Printer Brand:
Prusa

Printer:
I3 MK3S

Rafts:
No

Supports:
Yes

Resolution:
0.15

Infill:
25%

Filament:
Plast-Spaw PLA ASA PETG

Notes:
Use supports under front edge and upper overhangs. Take a look on the attached pictures - green are supports.