**OUTDATED** Headphone Holder with Cable Guide

***OUTDATED*** new V2 model here → https://www.printables.com/model/512261-headphone-holder-with-cable-guide-v2

You also hate running over your Cable with your chair? Fixed it!

Neatly organizes your Headphones and your headphone Cable on the edge of your Desk.

Available in multiple sizes from 30-50mm that should fit most desks, if i missed a size let me know and i will add it. 
 

The screw is a tight fit so it wont back out, if it doesnt fit right away scale it down a little in the slicer.

To mount the cable just gently feed it in a Z Pattern between the teeth of the guide. 

Print without support.
Part orientation like in the Picture (Thread gap up!)

2 Wall Loops
15% - 25% Infill
0.2mm Layer height
0.4mm Nozzle
 

Printed in Extrudr PLA NX2 on the Bambulab X1C,  53min to completion