7-Slot Vertical Double Stack 9mm Mag Holder

This magazine holder can be mounted using female, threaded, Neodymium magnets or screws (three pre-centered holes provided). I intentionally did not put in screw holes so that they can be drilled out to whatever size hole is needed, depending on screw size.

Holds up to seven Glock 17/19 or Springfield XD/XDM type 9mm, doublestack magazines. 

Recommend Printer Settings:
Infill: 50-80%
Supports: Trees or Organic from build-plate if supported. Otherwise, supporting the lip overhang from the print is the recommended minimum.

Pictured holders were printed using PLA+ and .15mm layer height with 60% infill.