CHiQ Fridge Replacement Shelves

Made a design to replace the shelves in my CHiQ Fridge.

-Long design
-Short design
-Joining piece for long design
_____________________________________________________________________________________

Printed with Anycubic Kobra Go - Using eSUN Grey PLA+.
The short shelf can print on it own, make sure to use tree support with auto painting. There are some large overhangs that need a bit of supporting.

The long shelf I cut in half using Prusaslicer and then slid into the the joiner. The joiner itself is a tight fit. I allowed a 0.5-1mm clearance but it can still be tight - if needed print a small test cut and see if pieces will slide through. If not scale up slightly to allow a bit more space.
-Same style of supports when cut in half. Large overhands need a bit of tree support but nothing extreme, let prusaslicer do the work for you.