This is mainly for sharing STL with a friend, will come back with detailed instructions later.
Each wing requires: 1 wing tip, 2- 2 hole pieces, 2- 3 hole pieces, 1 Long piece, 1 short piece
In total for the 4 wings you will need two different sets. One smaller the other larger.
complete total pieces: 28 (4 wing tips, 8- 2 holes, 8- 3 holes, 4 Long pieces, 4 Short pieces.)
You'll have to do some math to figure out the exact measurements, I'm still finessing mine.
For this cosplay I'm printing mine at 4 mm thick. 30 mm wide.
Long wing piece is for back plate. It is supposed to be longer than the S piece. goes on top. Attaches to top hole of 2nd 3 hole piece (the one that attaches to the 2 hole attached to wing.
Short Piece is also for backplate goes below Long piece attaches to 2 hole piece that's attached to wing tip 3 hole. It attaches to bottom hole.
3 Hole pieces cross each other at middle point, shorter gap on bottom. you will need 2 for 1 wing. 1st hole attaches to back wing tip hole. 2nd one the top hole attaches to L wing piece.
2 Hole attach to bottom hole on the 3 Ho piece. 1st 2 ho attaches to first hole on wing tip. 2nd attaches to lower hole on 3 hole piece. It should attach to the bottom hole on the piece that attaches to the back hole on wing tip.
Lucifer has 4 wings, the smaller wings are on top near his shoulders. The larger ones on bottom near his lower back. It's up to you to figure out how big you want them.
Make sure you give yourself plenty of time for trial and error, remember, Rome wasn't built in a day.
The diamond buttons are also included. I just glued them on top of the buttons that were already on the coat.
The author marked this model as their own original creation.