Gamesir X2 (Pro) Ergo Grip

EDIT 2: v5 - further ergonomic improvements, enlarged cutout for proper USB charging. Final version for now. There may be a sharp little nub you need to trim/sand where two angles meet near your palm, I am too lazy to fix the model at this point. I superglued my handles on because I'm insane but adhesive tape would probably work.

EDIT: v4 - Improved ergonomics (a little less chunky at the bottom). Added the usb port but measured wrong and it's way to small - oops. Fix incoming. Can still download v3 if you have large hands and want a chunkier grip.

Designed this to improve ergonomics, especially for the right hand - I always felt like the thumbstick was far too close and low for comfort.

Needs to be attached with double stick tape or adhesive. I printed it with the back side on the print bed with organic supports for 30degree or greater angles. You may be able to print without supports at all depending on your setup.

Just mirror it in your slicer for the left side.

To do (possible future versions): 

• make usb-c charge port accessible
• further improve ergonomics
• design a non-adhesive method of attachment