Prusa Mini PSU Mount Ikea Platsa Rear with Cable Clip

Needed tomething for my Prusa Mini to stay portable. It was a pain to reach my enclosure from the back, so I decided to put the PSU in the right rear of the Enclosure and only Plug in the PowerWire. So I can easily take the PSU and the printer apart and use it anywhere else with another Power Wire. I liked triangular design, so I managed to print some for "cooling" and mostly for optics. The mount will be screwed with 2 Screws to the Platsa Holes. First try if your screws can't scratch the PSU. Had some which fit perfectly and some that were 0,3mm to wide!

Printed in place without supports. Front hole is to reach the bottom screw - upper can be reached easily from top.

Printed in PETG with 3 perimeters and it's really stable.

Bonus: Added a cable clip, so the Output Cable goes to the bottom where usually the mini sits.