Cloth hanger clip

A simple-looking design but has a lot that went through!

Design Optimized for :

• Print time
• Stiffness 
• Material volume

How to use:

• These are just push-in and pull-out types of clamps
• Place the clamp over the rod and Clothing 
• Push the clip and it holds onto the clothing 
• To remove it, simply pull out the clip

Configurations:

You can scale the profile in Z

• I am using 4mm and 6mm thick two clips
• for the case where it needs more expansion. I use the 4mm thick one
• for the thinner clothes, I use the 6mm wide clip

Print parameters that worked for me:

• 0.3mm layer height 
• No supports
• No infill
• Print time was roughly 18min for two different clips with above mentioned thicknesses