Can Lid (Soda, Water, Beer, etc.)

Fits perfect! My daughter is trying to cut back on soda and often will put an open soda back in the fridge for later and this helps a lot!

PLA, 0.16 layer height. It works to make less liquid fall out, but some does still fall out. I printed it in PLA, so that is my fault. I believe it would work perfectly in TPU, but I don't have that🫤

Easy print, genuinely useful. Thanks for this

Thank you for such a great design, I made two for my girlfriend and it's perfect. I did increase the diameter by .5mm to give it a loose enough fit to remove with one hand, and added some flair.

this is so cool. me and my friends love it. printed in red tpu on elegoo neptune 4 max

Printed great, can't wait to print more of these!
(Wouldn't let me set a star rating :o) (edited)

In my case it's more about keeping the bugs out than keeping the fizz in, but yes, this is exactly what I needed. Works on first print from the regular size, too. I used 83A hardness TPE, so it's extra squishy.

Ehhhm, Maybe only print PLA if u want to keep the can as a decoration, its hell to get off even the standard size

I love your model . I made a few for the house.

Made the normal fit one with Overture TPU and it is just the right amount of snug. Can hold the can up by the cover and don't have to pry it off. (edited)