Door latch for spring door stopper

This is a door latch that can be used with the spring door stoppers typically found in the US. I used rounded corners to make safer when the door is not latched.

Update-
Changed the latch part a little bit.
Added a screwed version to be used with #6 wood screw.

Below are the print settings that I have used-

Filament - PLA (But PETG/ABS should be fine too)
Infill - 15%
Layer height - 0.2mm
No support

Please make sure that models are placed on the plate correctly. Use the “Place on Face” function in SuperSlicer or equivalent functions in other slicers.

For the no screw latch, the taped side might need to be roughened up a little bit with a sandpaper, otherwise the tape won't stick to it for very long as 3d printed side walls are pretty smooth and slippery.