Voron 0 (0.1/0.2) Toolhead for Sherpa Mini and Dragon SF/HF

For this build you will need (refer to photos):

• 6x heatset insets (M3x5x4)
• 2x M3x16mm for X Carriage
• 2x M3x8mm
• 2x M3x18mm (can eventually be used 20mm, but with 1mm washer on top)
• 2x M3x12mm
• 4x M2.5x8mm
• 8x M2 6/8mm
• 8x M2 nut
• around 15mm of PTFE going between hotend and extruder
• 2x 4010 fan
• 1x 3010 fan

You can reinforce both part fans by installing 31mm 2/4 PTFE rebar behind your hotend, using 2xM10 self-tapping screws (see last photo to see how it is mounted in front).

Keep in mind that this toolhead is about 3mm wider on each side than original Mini SB, in place where (sensorless on V02 at least) homing occures.