Torch and battery holder

Decided to use this as an exercise for my first use of OpenSCAD.

This is just a simple bracket to hold an LED torch and a spare battery for it. In my case this is for a cheap torch from eBay that uses 18650's.

If the torch diameter is big enough, it will leave two holes for batteries instead of just one.

Lastly, there is an optional recess to put glow in the dark tape. Handy if this is for emergency use torches.

The OpenSCAD file is included too.

Just measure the diameter of the torch and battery (add a little so its not too snug a fit) and enter into the customiser. Most other parameters can also be tweaked.

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK3

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

10%

Filament: Das Filament PLA