Gridfinity holder for Olight S2R Baton version 1 flashlight and charger

Gridfinity holder for Olight S2R Baton version 1 flashlight and magnetic charger.

Only tested with Olight S2R Baton version 1. 
I don't know if version 2 of this flashlight fits?

The overhang of the slot for the charger needs support material.
No support is needed, in other places.

The fit for the charger, is tight on purpose. 
The charger is supposed to click into place, when pushing it through the slot.

The spring contact in the center of the charger needs to be pressed down, while sliding it through the slot.

To make sure that the magnetic charger stays in place, when removing the flashlight:
I used double sided tape.

I used a 0.2mm layer height with a 0.4mm nozzle. 

I printed in PLA

Included is the f3d file