100hex (Remix II) modelos 361-Spiral_28_Fixed

This is a fixed remix of the Spiral_28 design by:

https://www.thingiverse.com/pelandintecno/designs

https://www.thingiverse.com/thing:4524116

100 Hex:

https://tecnoloxia.org/100hex/

https://www.thingiverse.com/thing:2477471

When attempting to slice in Prusa Slicer or Cura the original model returned an 8 (?!?!?) hour print time and gave errors of open edges. I attempted a fix earlier but it did not work properly (print head was making multiple unnecessary travel movements and not extruding). 

I performed the following steps to repair this model:

1. Open with Prusa Slicer.
2. Right Click: "Fix through NetFabb"
3. Export repaired model
4. Open exported model with Tinkercad.
5. In Tinkercad change the height to 90mm.
6. Then using invisible boxes I located the best looking spot and blanked everything above/below.
7. Resized the object to 2mm (original height).
8. Resliced in Prusa slicer.

Print time was reduced by 6 hours, and it printed properly in 2ish hours with no unnecessary movements.

Thanks for taking the time to make and share these Pedro, I successfully printed Nightmare Before X-MAs from this set, and the portrait from your first set of 360.