Rook Evolution BLTouch adapter

I used a clone, but the measurements should be the same.

Shifted to reduce the Y offset as possible without blocking the part cooling fan.

The nubs locate into the existing holes on the toolhead and you'll need a 5mm longer m3 bolt to pass through. In my case that meant moving from m3x45 to m3x50.

Allows decent access to the bed, but can't reach all the way to x 0 or y 150.

My probe offset is x=31, y=-25, z=0.500, but ymmv.

Uses 2x m3 nuts and m3x6 screws