ELEGOO NEPTUNE 3 PRO/PLUS/MAX DUAL 5015 BLOWER FANS SHROUD W/ 8MM NOZZEL CAM CLAMP

version 2 of my dual 5015 fan upgrade for the elegoo neptune 3 pro plus and max.  

This model has increased air flow flow over v1. 

Helps keep the stepper cool by pulling air directly off uses much less support material, prints fater, and cleaner.

I have also incorporated a removeable crossmember with 8mm endoscope mount for a nozzel camera !!!

ENDOSCOPE CAMERA 1920p (ios/andoid)

https://amzn.to/42TKAkg

USES 2 5015 BLOWER FANS 

https://a.co/d/6iPVarf

USES TWO M4x20 SCREWS FOR FANS

https://a.co/d/fT4I6h2

USE THE FACTORY SHROUND MOUNTING HARDWARE OR TRY THESE ULTRA LIGHTWEIGHT TITANIUM ONES. 

https://a.co/d/2fGuEuL

2.0 PIN CONNECTOR FOR FANS SO YOU DONT HAVE TO CUT YOUR STOCK ONES LIKE I DID. 

https://a.co/d/by60ijS *

*IMPORTANT NOTE ABOUT THE CONNECTORS LISTED ABOVE:

RED AND BLACK ARE BACKWARDS COMPARED TO ELEGOOS WIREING! MUST SWAP RED AND WHITE TO GET FANS TO WORK WHEN USING THESE CONNECTORS

START OUT AT 50% MAX FAN AT FIRST AND TUNE IT TO YOUR ENVIRONMENT.  

THE BASIC FACE PLATE IS POSTED HERE AS WELL. AND I LEFT IT VERY GENERIC SO YOU CAN PLAY WITH INFILL PATTERNS TO GET THE LOOK YOU WANT. :)