EBB36 Stealth Burner mount with Drag Chain

So i got the EBB36 v1.2 and usually people use it with Umbilical, but i wanted to use drag chain instead and i couldnt find a decent one, the ones that i found usually had the canbus sitting so low that the heater wires would rub against the chain specially at min x. had to change my heater for that matter. So i designed my own which is both sitthing higher up and has a post that prevents the chain from rubbing anything above it. this is a 3 hole mount but you can use 1 screw(just like what i did) to hold your 2 screw drag chains. 

it needs:

1 standoff (provided with the board)

3 + 3(for dragchain) M3 insert nuts

1 M3x8

1 M3x15 

Note: 2 of inserts go onto the chain mount part, and the other is used for the left screw that holds the canbus. so the canbus board has the shorter m3 screw on the left and on the right we have the M3x15 that goes through the canbus and canbus mount and gets screwed to the heatset insert in the dragchain mount.