Shaper Origin Hex Wrench Wall Mounts

Wall mounting brackets for both the long hex wrench that comes with the Shaper Workstation as well as the short hex wrench that comes with the Shaper Origin kit. They're quite small—I was able to print both with an 0.6mm nozzle with the 0.35mm Speed preset on my MK3 in just 15 minutes. Mount on the wall or any other vertical surface using some 3M VHB tape or another two-sided PSA tape.

Print instructions

As long as you put the back surface against the build plate this should print with any reasonable settings. I used some cheap PLA and a larger nozzle (0.6mm), but if you're rough with your tools maybe some PETG might be in order. No raft or anything needed if you have decent adhesion.