This stand has a bearing inside to help you turn the phone on its Z axis.
It holds the phone nicely in a comfortable angle whole working on your desk.
Magsafe used
bearing used (608)
Print settings:
Top:
supports: Yes, do build plate only, but add supports for the top hole (not for the cable)
(as shown in the image)
res: 0.2 mm
infill: I did 40% for the first 27 mm and then changed to 20% infill to make sure the bottom is heavier than the top.
Bottom:
supports: Yes
res: 0.2 mm
infill: 20%
The author marked this model as their own original creation.