Honeycomb homes for LPS

Have you ever had these little monsters (Littlest Pet Shop) everywhere on the kid's room floor? Was it impossible to walk anywhere even if you cleaned them up somewhere in a box every day... again and again? Then you might want to install these little houses and maybe you will be surprised as we were at our home :-D

Print instructions

Nozzle: 0.4
Layer height: 0.3
Perimeters: 2
Top/bottom layers: 2/2
Infill: 10%
Supports: No
Material: PLA

TIP: Install them on a wall using both-sided tape (small pieces) - just test which tape works best for your wall to not screw it up too much when removing it in future or choose a place where you don't care :-D