Update 2 : V2 now available here : V2 Crayford Focuser Reducer 1:10
Update 1 : Added a fillet on the reducer support + added all step files
The exact reduction is around 1:10.24
WARNING : This is not a "print-and-go" solution, you will need to customize one of the parts that will be used to fix it to the focuser
WARNING 2 : The Planetary Gear are CRITICAL pieces of this assembly. Their printing MUST be ALMOST perfect to avoid any problems or hard spots. Check your slicing up-close for any bridges between parts and feel free to test your prints BEFORE assembly.
You must have almost NO resistance when you turn the planetary gear reducers slowly individually.
When you will print the planetary gear, due to their very small size, they will probably be stuck and not move. You need to use something (like a flat screwdriver) to make them turn GENTLY and SLOWLY to not damage the hole.
Try to make multiple prints and experiment with settings until you get perfect (or almost) planetary gears for assembly.
Parts to be printed :
Materials needed for assembly :
1) Start by cutting 2 nails to have a 18.5mm size (full size including head)
2) Add a point of superglue on each hole (except center) of the external side of the Main button
3) Insert previously cut nails in each hole. Apply pressure to ensure the flat head is correctly inserted
4) Join the Insert C and the Reduced button. Insert with your hand slowly, then complete with hammer
5) Join the Insert D and the Planetary Gear B. The longest side goes in the middle of the Planetary gear. Insert with your hand slowly, then complete with hammer
6) Almost similar as the beginning, add a point of superglue on each hole of the carrier (largest side) (except center), and insert a nail in each. Apply pressure to ensure the flat head is correctly inserted
7) Insert the carrier into the remaining side of the Insert D. Push until it touch the marked delimitation on the Insert.
8a) Insert carrier nails into the planetary gear A. Put everything on the planetaries support fixation. Planetary gear A must be on the side of the support with the 2 holes.
8b) Cut nails at correct size (should be around 14-15mm full size including head) and undo the previous step
OR
8) Cut nails at 14-15mm (full size including head)
9) Insert the remaining side of Insert C in Planetary Gear A. Complete with hammer
10) Insert carrier nails into the planetary gear A. As you can see, there is 2 "spots" for the planetary gears in the Planetaries support part. Apply superglue on the 2 spots, then put on the assembly as a whole and apply pressure until superglue has fixed the system. Planetary gear A must be on the side of the support with the 2 holes.
11) Finally, correctly align planets from Planetary Gear B with the nails inside the Main Button and insert the system within the button
12) If you firmly maintain the reducers support part with your hand, you can now use the Main and Reduced button. The objective is now to customize the reducers support part to bind it to your upper telescope assembly ! It must be static for the movement transmission to work.
This design was first to be used with this amazing 2" crayford focuser created by marcosatm here : 2in Crayford Focuser
Thanks for letting the step files available too !
But it can be retrofitted to any other crayford focuser if there's enough clearance. It may need a little customization.
This work is licensed under the Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License (CC BY-NC-SA 4.0). To view a copy of this license, visit http://creativecommons.org/licenses/by-nc-sa/4.0/
Realised using an Ender 3 V2 Neo with a 0.3 nozzle and 0.16mm resolution using PETG
The author marked this model as their own original creation. Imported from Thingiverse.