SAMURAI logo from Cyberpunk - sign

Wake up SAMURAI, we have city to burn.
My creation of Samurai logo from Cyberpunk 2077 I hope you will enjoy it :).
Printed on MK3+, little bit of sanding at the end should remove some imperfections, just be carefull so you don't remove the tiny details on printout.
Dimensions (h x w): 15mm x 13mm

Stand: https://www.prusaprinters.org/cs/prints/154505-sign-stand

Print instructions

IMPORTANT - there are 2 colour changes as follows, 2.0-2.2 (Silver) and 2.4 - 2.6 (Red) Start with black 0-1.8.
2 perimeters
15% infill
Ironing for top layers only. Use height range modifier for layers 2.0 - 2.7 with ironing turned on. Flow was decreased to 10%.
I used top layer extrusion multiplier raised 0.45 because I'm still fighting with gaps between perimeters.