Woman in a Spacesuit Graphic Art (Layer swaps, no MMU needed)

The Spaceman needs more friends!

As usual, the model is generated in HueForge and requires only swap at layer height, no MMU needed.  Instructions for Bambu Studio and PrusaSlicer layer swaps.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

For a traditional orange space suit, here are some suggested filaments.  But have fun!  This model does blend more than the Spaceman so you can get cool effects by careful filament selection, but it should look good with shiny filaments too.

Filaments Used:
   JAYO Black Transmission Distance: 0.3
   SUNLU Red Transmission Distance: 7.5
   TPOIMNS Yellow Transmission Distance: 6.5
   JAYO White Transmission Distance: 6

Swap Instructions:
   Black until layer #6 at 0.56mms
   Red until layer #12 at 1.04mms
   Yellow until layer #16 at 1.36mms
   White until layer #26 at 2.16mms

Photos courtesy of DstrbdMedic167 from the Polymaker Discord.  Join us there to share your prints and learn about filament painting!