44.5 MM Bracket for Knock Off Lack Table

This is a bracket I designed for a knock off lack table I bought off of Amazon. I designed it mainly to mess around with the rib command in fusion 360. There are lots of fancy parametric bracket designs out there but I like the look of this one. Its designed to be used with m3 screws. Although up to m5 should work, the threads should sort of cut through the hole and make it the appropriate size.

Id recommend flipping it on its side to alleviate the bracket potentially breaking between the layers while in use, printing with 3-4 walls, 30% gyroid infill, and I also used Cura's experimental “Make Overhang Printable” setting to get rid of the need for any supports or anything. It just puts a small fillet under each of the ribs.