Creality Halot One (CL-60) Drip holder

When using Min_s_Craft and BigMrP's model, I was confused by the fact that the part under the screw is much thinner and therefore when I use the drip cap, I have to turn the screw several times to tighten it, while the resin drips.... and when I want to fit the platform in place, it does not go up.... and I have to turn the screw several times to loosen it.

Now both the platform and this model are the same size, so working with one hand is much easier.

The other thing I changed is the factory support. I removed this because it was too thick and since the print settings apply to it, it wastes time and money (material).

The supports prints much faster, its density and speed can be adjusted by everyone...