Voron Tap R8 Switchwire

Modified mount of VORONTAP R8

28/09/2023-I apologize, the belt lock has an offset of 0.595 in the -Y direction which causes the belt to misalign with the pulleys which could lead to a deterioration of the same cause rubbing on the edge. I corrected the pieces and labeled with "FIXED"

I have not printed jet and Voron team said  switchwire bed are NOT rigid enough. Use at your own risk.

V1 are flat on connection point, V2 has a little step.

Belt connector is secured to main body with two heat-insert and  two M3x12. This design should let belts untouched in case of disassemble.

Follow the Voron Tap instructions for installation: https://github.com/VoronDesign/Voron-Tap

Part should be printed as show in picture . No supports needed.