Ultrasonics mount (HC-SR04 to SG-90)

This is a printable design to mount the HC-SR04 ultrasonics sensor to the Micro SG-90

To make this design work you'll need four small screws (or two - for each opposing corner) to mount the ultrasonics sensor to the print. And you'll need the 90* degree half mount plastic tab that comes with the SG-90.

The pentagonal hole between the two ultrasonics Holes is designed so the user can clearly see the four markings on the sensor (VCC, GND, TRIG, ECHO), meaning the pins must be on the top side of the mount.

Print in:

• 0.2mm layer height
• 10-15% infill