CR-6 SE Bed Handle

This is a remix of this fantastic bed handle.

I broke the original design trying to snap it on. And didn't read the suggestion to soak the snap on ends in hot water.

This design requires you to remove 2 screws and the spacers, insert the spacers into the holes and put the screws back in through the spacers and part. Takes less than a minute.

The spacers are 8mm and the holes are 8.2mm which on my CR6 is a nice tight fit.

Print Settings

Printer Brand:

Creality

Printer:

CR-X

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

20%

Filament: ERYONE PLA+ Red

Notes:

PLA works fine as well.