CR-6 SE Rear Cable Tidy with Spool holder

This is a great way to get the cable out of the way of the spool.

This is remixed so you can also mount the original spool holder arm from the same location at the rear. This allows loading the spools from the front.

You can re-use the M5 bolt and need an M5 nut for the bottom. The nut is helpful but it shouldn't come out without it either.

Printed on the CR-6 SE.

Enjoy.

Print Settings

Printer Brand:

Creality

Printer:

CR-X

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

35%

Filament: ERYONE PLA Blue or Red

Notes:

Printed on the CR-6 SE.

I increased the XY support distance to 1mm make it easier to remove the support around the spool pivot. This isn't necessary, just helps to remove the support. Increasing the "Support Overhang Angle" to 80% also helps to reduce the amount of support in the spool holes which can be a pain to remove.

Category: 3D Printer Accessories