Dice flower pot vase mode with inner pot

I found similar designs, but they were not focused on being printed in vase mode. So I quickly decided to design my own and also make an inner pot in the right size to drain the water. 
The dice pot should be water proof when printed in vase mode.

The length of every side is 70mm, but you should be able to scale from that to any size you want in the slicer. 

Print settings:

• Spiral vase mode
• extrusion width: 0.6 mm
• layer height: 0.2 mm
• bottom Layer: 4 Layer
• speed perimeter: ~ 20 mm/s

Keep the speed low to allow the filament to be cooled, the pot doesn't have a big diameter!

I over extruded my 0.4 mm nozzle to 0.6 mm. Just give it enough time to melt and cool and you be fine.